Bajaj pulsar F250 2022 Service Station Manual page 13

GENERAL INFORMATION
Liquid Gasket, Non-permanent Locking Agent
For applications that require liquid gasket or a non-permanent locking
agent, clean the surfaces so that so oil residue remains before applying
liquid gasket or non-permanent locking agent. Do not apply them
excessively. Excessive application can clog oil passages and cause
serious damage.
Circlips, Cotter Pins
Replace the circlips or cotter pins that were removed with new ones. Take
care not to open the clip excessively when installing to prevent deformation.
Press
For items such as bearings or oil seals that must be pressed into place,
apply small amount of oil to the contact area. Be sure to maintain proper
alignment and use smooth movements when installing.
Ball Bearing and Needle Bearing
Do not remove pressed ball or needle unless removal is absolutely
necessary. Replace with new ones whenever removed. Press bearings
with the manufacturer and size marks facing out. Press the bearing into
place by putting pressure on the correct bearing race as shown.
Pressing the incorrect race can cause pressure between the inner and outer
race and result in bearing damage.
Press inner race - when bearing is to be fitted on shaft.
Press outer race - when bearing is to be fitted in the bore.
Service Support - M/C
7
Service Station Manual