Table of Contents
Advertisement
BEFORE YOU CALL
Solutions to Common Problems:
Before you call for service, review the following list. It may save you time and expense.
Possible solutions are provided with the problem listed.
Problem
Entire appliance does not
operate.
Poor baking results.
Flames inside oven or smoking
from oven vent.
Oven smokes excessively when
broiling.
Oven control panel beeps and
displays any F code error.
Oven portion of appliance does
not operate.
36
Cause / Solution
Appliance not connected. Make sure power cord is plugged properly into outlet.
Check your fuse box or breaker box to make sure the circuit is active.
Electrical power outage. Check house lights to be sure. Call your local electric
company for service outage information.
Oven Problems
Many factors affect baking results. Use proper oven rack position.
Center food in the oven and space pans to allow air to circulate. Preheat the oven to
the set temperature before placing food in the oven.
Try adjusting the recipe's recommended temperature or baking time.
Excessive spills in oven. Grease or food spilled onto the oven bottom or oven cavity.
Wipe up excessive spills before starting the oven.
If flames or excessive smoke are present when using broil, see
page
26.
Incorrect setting. Follow the
Meat too close to the broil element or burner. Reposition the broil pan to provide
proper clearance between the meat and broil element or burner. Remove excess fat
from meat. Cut remaining fatty edges to prevent curling, but do not cut into lean.
Grease build up on oven surfaces. Regular cleaning is necessary when broiling
frequently. Grease or food splatters will cause excessive smoking.
Oven control has detected a fault or error condition. To clear the error, press the OFF
key on the control panel. Once the error code is cleared, try the bake or broil function.
If the F code error repeats, turn off the power to appliance, wait 5 minutes, and then
repower the appliance. Set the clock with correct time of day. Try the bake or broil
function again. If the fault recurs, press the OFF key to clear.
The time of day is not set. The clock must be set in order to operate the oven. See
"Setting the Clock"
on
page
Be sure the oven controls are set properly for the desired function. See
Features"
starting on
page 20
in this manual or see Entire appliance does not operate in this checklist.
"Setting Broil"
instructions on
21.
and review instructions for the desired cooking function
"Setting Broil"
on
page
26.
"Oven Control
Advertisement
Table of Contents
