Problems Accessing Pulldown Menus Of Spmon; System Monitor Displays Blanks Instead Of The Expected Information - IBM RS/6000 SP Problem Determination Manual

This soft copy for use by IBM employees only.

2.5.2 Problems Accessing Pulldown Menus of spmon

On the Control Workstation, if you run
interface of
any menu in
spmon
with numlock on, you can still access the mwm root menu and aixterms window
menus. This problem is reported under IX50314. This problem was tested on
the ssp.gui.2.1.0.6 level.

2.5.3 System Monitor Displays Blanks Instead of the Expected Information

If the system monitor panels are displaying blanks instead of the expected
information after installation, or if the ControllerResponds indicator on the
system monitor frame environment panel is red, or if the
/var/adm/SPlogs/SPdaemon.log reports that the Frame Controller is not
responding, then do the following:
This result indicates that the ssp.basic option is installed.
•
If the verification in the previous step succeeds, then check your PATH
environment variable. You can achieve this by using echo $PATH.
−
Add /usr/lpp/ssp/bin to your PATH or use the full path name with the
command.
spmon
, and the numlock key is on, then you will not be able to access
spmon
by clicking on Files or SP with the mouse. If numlock is off,
works without any problem. When you experience this problem with
•
Verify PSSP Installation.
Run verification tests to ensure that installation is complete. You can
smit
achieve this using
# smit sman_verify
or, from the command line, enter the following:
# /usr/lpp/ssp/bin/SYSMAN_test
HOST: sp2cw0
------------
SYSMAN_test: Verification succeeded
SYSMAN_test: Executing test on all active nodes
HOST: sp2n01
------------
SYSMAN_test: Verification succeeded
HOST: sp2n02
------------
SYSMAN_test: Verification succeeded
HOST: sp2n03
------------
SYSMAN_test: Verification succeeded
. .
. .
. .
HOST: sp2n13
------------
SYSMAN_test: Verification succeeded
HOST: sp2n14
------------
SYSMAN_test: Verification succeeded
SYSMAN_test: The number of nodes that were not tested is 4
This output confirms that your installation is complete.
spmon -g
in order to get the graphic
or from the command line. Use
Chapter 2. The Installation Process
spmon
smit
as follows:
33