Install_Cw Diagnostics - IBM RS/6000 SP Problem Determination Manual

This soft copy for use by IBM employees only.
Path Problems
Kerberos Problems

2.4 install_cw Diagnostics

Before you proceed further, ensure that you are authenticated as a valid user
with a valid ticket. If required, run the
RS/6000 SP authentication services specifying the administrative principal name
that was used when authentication was set up.
The full path of this script is /usr/lpp/ssp/bin/install_cw.
install_cw runs on the Control Workstation and does the following:
If running
found
which setup_authent
setup_authent
.profile file or use full path.
Here are the paths required by kerberos that you should
put in your .profile file:
/usr/lpp/ssp/rcmd/bin
/usr/lpp/ssp/kerberos/bin
/usr/lpp/ssp/kerberos/etc
/usr/lpp/ssp/bin
For tips to solve various kerberos problems, refer to 3.8,
"Solving Problems" on page 82 in Chapter 3, "Kerberos"
on page 71. You may also take a look at the
setup_authent script flow chart in A.1, "The setup_authent
Script" on page 229.
•
Configures the Control Workstation
• Executes /usr/lpp/ssp/inst_root/ssp.basic.post_i
After PTF 12, this script is not called directly.
There was a dependency on ssp.basic.post_i after installation which caused
several problems. It was most easily seen when a node had been restored
from a mksysb in which the variable RM_INST_ROOT is set to yes in the
bosinst.data on the system from which the mksysb was taken. This caused
inurid -r
to be run when the system was restored.
pssp_script calls ssp.basic.post_i
node properly after installation.
The pssp_script has been changed to call post_process and post_sysctl. The
post_process and post_sysctl files are equivalent to the post_i
ssp.basic.post_i and ssp.sysctl.post_i files, respectively, and they are located
in the /usr/lpp/ssp/install/bin directory.
•
Installs smit panels
• Configures SDR
• Updates /etc/services and /etc/inittab
•
Starts SP daemons
•
Creates /spdata/sys1/spmon/hmacls file with the administrator's ACL for
hardmon
•
Configures default system partition
setup_authent
gives the error
, then check your path for
command to get the correct path to
. Include correct kerberos paths in your
kinit
command to get a valid ticket from
during install and fails to customize the
Chapter 2. The Installation Process
setup_authent not
setup_authent
. You can use
29