Advertisement
User-Selectable Features
Your Sabre vehicle security system allows you to set many of its features to your
own personal preferences. We have made the programming procedures very
simple: to make a change, you just flick the valet switch a few times.
The system comes from the factory with all of its features pre-programmed as noted
in the table below and on page 6. To change any of the settings, use the procedure
noted. To restore the feature to its factory setting, just repeat the procedure:
1. Select the feature you wish to program from the table on the following
pages. Note the number of flicks and chirps associated with that feature.
2. Insert your ignition key and turn it to the "ON" position.
3. Immediately flick the valet switch back and forth, counting the number of
chirps you hear. Stop when you reach the appropriate number of chirps
4. If noted, do the "secondary action."
5. You will hear one or more chirps (as noted in the "program completion con-
firmation" section) to confirm that you have changed the feature setting.
Turn the ignition off.
6. Repeat steps 1-5 for any other features you wish to program.
Programming Table for User-Selectable Features
# of
Factory
flicks &
Feature
setting
chirps
AutoArming
4
ON
AutoArm
5
OFF
& Lock
Arm/Disarm
Chirp Confir-
6
ON
mation
FACT —
False Alarm
ON/OFF
Control and
7
Test/Tamper-
ing Warning
Add a New
Remote to
8
—
Channel 1
(arm/disarm)
Secondary
completion
action
confirmation
—
seconds after
—
seconds after
—
seconds after
—
seconds after
Press remote control button I
5
Program
Result
1 chirp 3
Change state from
ON to OFF or vice-versa
last step
1 chirp 3
Change state from
ON to OFF or vice-versa
last step
1 chirp 3
Change state from
ON to OFF or vice-versa
last step
1 chirp 3
Change state from FACT
to Tampering Warning
last step
Button I/channel 1 code of
1 chirp
new remote control has
been memorized
Advertisement
