Table of Contents
Advertisement
Your Arrow II allows you to set many of its features to your own personal preferences.
The system comes from the factory with all of its features pre-programmed as noted
in the table below. To change any of the settings, use the following procedure. To
restore the feature to its factory setting, just repeat the procedure:
1. Select the feature you wish from the table below. Note the number of of flicks.
2. Turn your vehicle's ignition switch to its "ON" position.
3. Immediately flip the valet switch back and forth the number of times noted for
the feature you wish to program (to help you count, you will hear a single chirp
confirmation each time you flick).
a. If noted, perform the "Secondary action."
b. If noted, wait for the "Program completion confirmation."
4. Turn the ignition off. Repeat steps 1-4 for any other feature you wish to program.
Factory
Feature
setting
ON
AutoArming
OFF
AutoArm & Lock
Long-Term
OFF
Chirp Silencing
ON
FACT
Add a new remote to
—
channel 1
(arm/disarm)
Add a new remote to
—
channel 2 (remote
accessory)
Add a new remote to
—
channel 3 (silent
arm/disarm)
Add a new remote to
channel 5 (remote
—
controlled valet
mode)
—
Erase all channels
User-selectable features
# of
Program completion
Secondary action
flicks
—
4
—
5
—
6
—
12
Press remote control
13
button I
Press remote control
14
button II
Simultaneously press
both remote control
buttons I+II (or button
15
3 of the optional ACG
remote control)
On the optional
12-channel remote,
press LevelShift once,
17
then press button 1
(channel 5)
Wait 3 seconds for the
2-chirp confirmation
19
before turning the
ignition off
10
Result
confirmation
1 chirp = OFF
Change state from ON
2 chirps = ON
to OFF or vice-versa
1 chirp = OFF
Change state from OFF
2 chirps = ON
to ON or vice-versa
1 chirp = ON
Change state from OFF
2 chirps = OFF
to ON or vice-versa
1 chirp = OFF
Change state from ON
2 chirps = ON
to OFF or vice-versa
Button I/channel 1 code
1 chirp
of the new remote has
been memorized
Buttons II/channel 2
2 chirps
code of the new remote
has been memorized
Buttons I+II/channel 3
3 chirps
code of the new remote
has been memorized
Channel 5 code of the
5 chirps
new remote control has
been memorized
All remote control
codes have been
2 chirps
erased; program in new
remote controls
Hide quick links:
Advertisement
Table of Contents
