Advertisement
Quick Links
INSTALLATION MANUAL
Cab-Mate Flex (from Cab-Mate Open
3640)
Document ID:IM-CMFX
Last Updated: October 11, 2021
Pedigree Technologies recommends using a professional installer for optimal
results. Please let your Pedigree Technologies representative suggest a provider if
you need help with your hardware installations.
PedigreeTechnologies.com | Support: (701)-499-0022
Advertisement
Related Manuals for Pedigree Technologies Cab-Mate Flex
Summary of Contents for Pedigree Technologies Cab-Mate Flex
- Page 1 Cab-Mate Flex (from Cab-Mate Open 3640) Document ID:IM-CMFX Last Updated: October 11, 2021 Pedigree Technologies recommends using a professional installer for optimal results. Please let your Pedigree Technologies representative suggest a provider if you need help with your hardware installations. PedigreeTechnologies.com | Support: (701)-499-0022...
-
Page 2: Required Equipment
Current odometer reading • Type of diagnostics connector, if possible (6 pin, 9 pin square flange, 9 pin round threaded, J1962, Type II, etc.) Required Equipment Cab-Mate Flex Cradle Tablet Cradle Cable (5) #8 Self-tapping Screw 3/4 inch (5) M4 Screw 12mm... -
Page 3: Before You Begin
Cab-Mate Open 3640 to Cab-Mate Flex Before You Begin TURN TO THE LAST PAGE - WRITE DOWN THE REQUIRED INFORMATION!!! • Decide where the hardware components will be located. If necessary remove any dash panels with removal tool. • Must be within reach of the diagnostic cable to be installed. - Page 4 Cab-Mate Open 3640 to Cab-Mate Flex Install Cab-Mate Flex STEP THREE Attach the Cradle Mount to the back of the Cradle. Use the four short machine screws and star lockwashers. STEP FOUR Snap the tablet into the cradle and mount to the truck in a position where the driver can easily see and reach the tablet screen.
- Page 5 Plug the cradle cable into the 6 pin port on the Cab-Mate Flex. STEP FOUR Call Pedigree Technologies support to confirm installation before replacing any of the dash panels you may have removed during cable installation. Install Confirmation: 701-499-0022 You will be prompted for the following information during the set up process •...
-
Page 6: Alternative Installation
Place the empty 3640 LMU into the bracket on the Cab-Mate Flex cradle assembly and snap into place to secure. Cab-Mate Flex Cradle Assembly STEP THREE Connect the 22 pin connector from the Cab-Mate Flex cradle assembly to the LMU. PedigreeTechnologies.com | Support: (701)-499-0022... - Page 7 Cab-Mate Open 3640 to Cab-Mate Flex Connect Diagnostics Cable to Cradle STEP FOUR Plug the canbus cable that you removed from the LMU in an earlier step, into the 16 pin port on the 3640 LMU (the only open port).
- Page 8 Tablet in Cradle/LMU Cradle/LMU STEP SEVEN Call Pedigree Technologies support to confirm installation before replacing any of the dash panels you may have removed during cable installation. Install Confirmation: 701-499-0022 You will be prompted for the following information during the set up process •...