Advertisement
Prerequisites
Required Information [*needed for final activation of hardware - see last page]
•
Name of asset
(ex: Propane Truck #20)
*
•
Detailed information about the asset
•
State, area, organization, or group the asset belongs to (ex: North Region, MN tankers, etc.)
•
ESN of each device to be installed
•
Current odometer reading
•
Type of diagnostics connector, if possible (6 pin, 9 pin square flange, 9 pin round threaded,
J1962, Type II, etc.)
Required Equipment
Cab-Mate Flex Cradle
(5) #8 Self-tapping Screw 3/4 inch
(5) M4 Screw 12mm
(5) M4 Screw 8mm
(5) M4 Steel Nut
(11) M4 Star Lock Washer
(2) M4 Tamper Resistant Button Head HEX
Screw 20MM
Hardware Pack
Required Tools
•
Drill and assorted drill bits (ex. to mount cradle)
•
Slotted, Philips, and/or Torx bits (you may need tamper resistant Torx bits)
•
Panel removal tool or plastic pry bar (to remove dash panel(s) as needed)
•
Small socket set
•
Zip Ties (to hold cabling in place)
PedigreeTechnologies.com | Support: (701)-499-0022
(year, make, model, VIN, license plate, etc.)
*
(ESN is found on the back of each unit with a barcode)
*
Tablet
2
INSTALLATION MANUAL
Cradle Cable
In-Cab Readiness Kit
(booklet, stickers, DOT reference card)
Advertisement
