Advertisement
TURN TO THE LAST PAGE - WRITE DOWN THE REQUIRED INFORMATION!!!
•
Decide where the hardware components will be located. If necessary remove any dash
panels with removal tool.
•
Must be within reach of the diagnostic cable to be installed.
•
Must be protected from moisture, excessive dust/dirt, heat (away from heater vents) and
unobtrusive to driver operation or field of view.
•
Routing of the cable between the factory diagnostic port and the telematics device does not
cause excessive bending/kinking or areas where vibration may jeopardize the integrity of
the hardware.
•
Cabling must not impede function of any rotating or moving parts (ex. Steering
mechanisms, wiper mechanisms, or brake pedal)
•
Ensure that the mounting location has enough integrity to accommodate the additional
weight and vibration of the device.
Install Cab-Mate Flex
STEP ONE
Unplug the ELD Malfunction Indicator
Light from the LMU accessory harness.
You may remove the indicator light from
it's mouting. This will not be used with
the Cab-Mate Flex
STEP TWO
Plug the 5 Pin connector from the LMU to Cradle
Cable into the Aux 1 port of the accessory harness.
PedigreeTechnologies.com | Support: (701)-499-0022
Before You Begin
3
Cab-Mate Open 3640
to Cab-Mate Flex
Advertisement
