Table of Contents
Advertisement
3.4.2 FIELDS DESCRIPTION
3.4.2.1 «ABP info» – displays the data necessary to register the device in the LoRaWAN network with
ABP method (Activation By Personalization).
3.4.2.2 «OTAA info» – displays the data necessary to register the device in the LoRaWAN network
with OTAA method (Over The Air Activation).
3.4.2.3 «Key management» (not displayed in the "Simple" mode) – allows you to change the factory
device activation keys or reset the keys back to the factory settings (fig. 12).
Figure 12 — "Edit device keys" window at "Key management" field
3.4.2.4 «Device info» – displays information about the device model, its firmware version and time
in UTC (+0.00), factory number and meter verification date.
ATTENTION!
The date of the meter verification does not correspond to the current.
3.4.2.5 «Network info» – shows whether the device connecting to the LoRaWAN network and its
network address.
3.4.2.6 «Join network» button – launch the LoRaWAN network connection procedure with the
previously selected ABP or OTAA method. If the device is already connecting to the network, reconnection
procedure will occur.
3.4.2.7 «Link check» button (not displayed in the "Simple" mode) – when pressed, the device sends
a special signal to the LoRaWAN network, in response to which the network informs it about the number of
gateways that received this signal and the signal quality (fig. 13). This button only works while the device is
connecting to the network.
18
Advertisement
Table of Contents
