Connecting Your Monitor; Connecting The Displayport (Displayport To Displayport); Cable - Dell UltraSharp 34 User Manual

Connecting your monitor

WARNING: Before you begin any of the procedures in this section,
follow the Safety
NOTE: Dell monitors are designed to work optimally with Dell supplied
inbox cables. Dell does not guarantee the video quality and performance
when using non-Dell cables.
NOTE: Route the cables through the cable-management slot before
connecting them.
NOTE: Do not connect all cables to the computer at the same time.
NOTE: The graphics are used for the purpose of illustration only.
Appearance of the computer may vary.
To connect your monitor to the computer:
1. Turn Off your computer and disconnect the power cable.
2. Connect the DisplayPort, HDMI, or USB Type-C cable from your monitor to
the computer.
Connecting the DisplayPort (DisplayPort to DisplayPort) cable
NOTE: The default out of factory setting is DP1.4 (DP1.2 is supported).
If the monitor fails to show any content after the DisplayPort cable is
connected, follow the procedures below to change the settings to
DP1.1:
• Press the Joystick to activate the OSD menu.
• Toggle the Joystick to highlight Input Source, then press the Joystick to
enter the submenu.
│
30 Setting up the monitor
instructions.