Advertisement
Remote Controller Operation
Remove the battery cover from the remote control transmitter and install batteries.
Replace the cover. This remote uses 2 1.5V/AAA batteries.
Note: If not using for long periods of time, remove the batteries to prevent damage to
remote controller, and store the remote controller away from excess heat or humidity.
The batteries will weaken with age and should be replaced before they leak or corrode as
this will damage the controller. Dispose of the used batteries properly. Always keep
batteries out of the reach of children.
Universal Mode and Learning Mode
Your remote controller has two options: "Universal Mode" (mark "0") and "Learning Mode"
(mark "1").
If choosing "Universal Mode," simply move the switch to the LOWER position (mark "0").
Your fan with the remote controller is ready to use.
Note: If using Universal Mode, your fan can be controlled with other remote controllers
with the same setting.
To control the fan with a specific remote controller, choose "Learning Mode" by moving the
switch to the UPPER position (mark "1") and then follow the Learn Mode steps below.
Learn Mode
Important: Turn the power on for ONLY the specific fan you wish to pair with the remote
controller. Make sure to turn the power off for all other fans with which you use the same
remote controller.
Restore power to your fan, press and hold the "SET" button to pair the transmitter and
receiver. You must press the 'SET" button within 60 seconds of restoring power to the fan.
Note: Fan will at first operate at minimum speed and light will blink (if your fan has a light)
after you've chosen Learn Mode.
Note: If the power is already on, you must turn the power off and then back on for the
remote control setting.
Note: If you reset the controller to Universal Mode (mark "0") and later want to pair the
controller again to a specific fan, you have to repeat the Learn Mode steps.
The remote control buttons control the fan speed as follows:
Fan speed
1 = minimum speed
2 = low speed
4 = medium speed
5 = medium high speed
This button turns the fan off.
Forward/Reverse button: This button is to control direction of fan rotation. Press once
to change direction of the fan rotation. Fan must be running to reverse.
Breeze:
Press the Breeze button, fan will operate at high speed (6
to 5
, 4
, 3
, 2
, 1
at intervals of 30 seconds, and then change it from Low speed (1
th
th
rd
nd
st
4
, 5
, 6
repeat the cycle until the breeze mode is canceled.
th
th
th
Breeze mode can be erased by pressing either the power or speed control button.
Note: This remote controller has auto resume function. The fan will maintain the last setting when
turned back on, with the exception of Breeze mode.
3 = medium low speed
6 = high speed
) for 30 seconds, then automatically change
th
Page 6 of 8
Edge Outdoor Ceiling Fan
SET
1
0
SET
1
0
) to 2
, 3
,
st
nd
rd
1
0
Battery cover
Advertisement
