Table of Contents
Advertisement
802.11n
Enable/disable 802.11n protection, which increases reliability
Protection
but reduces bandwidth (clients will send Request to Send (RTS)
to access point, and access point will broadcast Clear to Send
(CTS), before a packet is sent from client).
DTIM
Set the DTIM (delivery traffic indication message) period value
Period
of the wireless radio. The default value is 1.
RTS
Set the RTS threshold of the wireless radio. The default value is
Threshold
2347.
Fragment
Set the fragment threshold of the wireless radio. The default
Threshold
value is 2346.
Multicast
Set the transfer rate for multicast packets or use the "Auto"
Rate
setting. The range of the transfer rate is between 1Mbps to
54Mbps
Tx Power
Set the power output of the wireless radio. You may not require
100% output power. Setting a lower power output may enhance
security since access to your signal can be potentially prevented
from malicious/unknown users in distant areas.
Beacon
Set the beacon interval of the wireless radio. The default value
Interval
is 100.
Station idle
Set the interval for the access point to send keepalive messages
timeout
to a wireless client to check if the station is still alive/active.
Airtime
Airtime Fairness gives equal amounts of air time (instead of
Fairness
equal number of frames) to each client regardless of its
theoretical data rate.
Set airtime fairness to "Auto", "Static" or "Disable".
Auto: Share rate is automatically managed.
Static: Press "Edit SSID Rate" to manually enter a % for each
SSID's share rate as shown below:
The % field must add up to 100% or a message will be displayed:
Airtime fairness is disabled if "Disable" is selected.
Press "Apply" to apply the configuration, or "Cancel" to forfeit the changes.
48
Advertisement
Table of Contents
