Signals; Sending The Configuration To Intesis - HMS Networks Intesis WMP User Manual

Home Automation (WMP) – Samsung NASA
TM
Intesis
Figure 4.6 Intesis MAPS Samsung NASA configuration tab after importing scan results
Consider that Chiller unit type are detected by the SCAN or can be configured manually in this section but there
are no signals available to control them from the WMP protocol.
Acnum
Acnum is the parameter or number associated to every ac unit. This parameter identifies the ac unit from the home
automation side.
In this gateway, this number corresponds with the unit ID available during the configuration process. This number
cannot be edited and is automatically generated during the manual or automatic (using SCAN) configuration
process. You can check the indoor units Unit ID number in its column.
For the outdoor units, acnum corresponds with the lowest Unit ID of its associated indoors.

4.2.6. Signals

All available WMP signals, its corresponding description and other main parmaters are listed in the signals tab. The
acnum of every unit is also displayed in a column in the signals view.

4.2.7. Sending the configuration to Intesis

When the configuration is finished, follow the next steps.
1.- Save the project (Menu option Project->Save) on your hard disk (more information in Intesis MAPS User
Manual).
© HMS Industrial Networks S.L.U. - All rights reserved
This information is subject to change without notice
Figure 4.12 Intesis MAPS Signals tab
User Manual r1.0 EN
URL https://www.intesis.com
15 / 25