Samsung Nasa Configuration - HMS Networks Intesis WMP User Manual

Home Automation (WMP) – Samsung NASA
TM
Intesis
1. Available commands
This is an informative section displaying all commands available for the WMP communication.
2. TCP Configuration.
This section allows to configure the TCP settings for the WMP communication with the Home Automation system.
•
Port: WMP TCP communication port setting. Default port 3310.
•
Keep Alive. Set the time of inactivity to send a keep Alive message. Default 10 minutes.

4.2.5. Samsung NASA configuration

Set parameters for the connection with Samsung NASA installation.
In Units Configuration section you need to enter, for each unit:
• Active. If it's active (checkbox at Unit xx), ranging from 1 to 64 indoor units that will be integrated (maximum
number of units will depend on Intesis model)
•
Unit type. Type can be one of the following: IU, HE, HT, EHS, AHU, ERV, ERV+, CHILLER. Available
signals will vary according to unit type. Chiller type units are not controllable with WMP protocol.
•
IU address. Address 0..63 of Unit in Samsung NASA R1/R2 bus. Remember that manual addressing of
Samsung indoor units is required.
•
OU address. Address 0..15 of Outdoor Unit in Samsung NASA R1/R2 bus. Remember that manual
addressing of Samsung indoor units is required.
• Description. Descriptive name to ease identification of the unit (for example, 'living room floor 1 unit', etc).
Additional to manual entry of each unit, autodiscover of present units in an R1/R2 installation is possible. To do so,
click the button Scan. The following window will appear:
© HMS Industrial Networks S.L.U. - All rights reserved
This information is subject to change without notice
Figure 4.4 Intesis MAPS Samsung NASA configuration tab
User Manual r1.0 EN
URL https://www.intesis.com
13 / 25