HIKVISION iDS-7204AHQHI-M1 Quick Start Manual page 26

Smart ATM Protection System Quick Start Guide
 Only when the person enters the detection region with covered face, can the alarm be
triggered. If a normal face is detected when a person enters the detection region, the
abnormal face appearing after that will not trigger alarm.
 The detected abnormal human face just triggers alarm once when there is person
operating the ATM. If you want to trigger alarms repeatedly, the person has to exit the
detection area and enters again.
 Check if the duration of the person operating the ATM has lasted for a certain time. The
duration from entering the detection region to exiting the region should exceed 20 s.
 If you want to simulate different kinds of events quickly, the time interval of simulating
different events should exceed 1 minute. Or go to Device Management > Remote
Configuration > VCA Config. Select the camera you have allocated for human face mode.
Then go to Advanced Configuration > Parameters to reduce Alarm Interval of
corresponding event to 10 s.
 Go to Device Management > Remote Configuration > VCA Config. Select the camera you
have allocated for human face mode. Then go to Advanced Configuration > Parameters to
configure Advanced Parameters as below.
1) Enter 65537 in Index No. text filed to enable the enhanced mode which can detect
the human face covered completely.
2) Enter 1 in Index Value text filed.
3) Click Set to save the settings.
26