System Cabling; Appendix - Hitachi CHROMASTER 5160 Instruction Manual

Appendix 1.5.4 System Cabling
In the Chromaster series, the module units are cabled by
plugging the e-Line cable into the e-Line connector at the rear
left of each unit.
NOTE: Before performing the e-Line cable connection,
please be sure to make sure that all the power
supplies for the module units to be connected are
OFF.
(1) Isocratic System/Low-pressure Gradient System
Chromaster
organizer
Chromaster 5410/ 5420/
5430 /5450detector
Chromaster 5310
column oven
Chromaster 5210
autosampler
Interface control
board
Chromaster 5110
pump
Appended Fig. 1-10 e-Line Cable Connection
Appended Table 1-3 Cables to be Used
e-Line cable 1) (50 cm)
e-Line cable 2) (80 cm)

APPENDIX 1 - 18

P/N 890-6105 (attached to each unit)
P/N 890-6107 (attached to autosampler
and interface control board)
e-Line cable 1)
e-Line cable 2)