Piping Installation; Preparing Refrigerant Piping; Refrigerant Piping Requirements - Daikin RXF50D5V1B Installer's Reference Manual

7 Piping installation

In this chapter

7.1 Preparing refrigerant piping

7.1.1 Refrigerant piping requirements

RXF50~71D5V1B
R32 split series
4P519439-15Q - 2021.10
7.1 Preparing refrigerant piping ...................................................................................................................................................
7.1.1 Refrigerant piping requirements ...........................................................................................................................
7.1.2 Refrigerant piping insulation..................................................................................................................................
7.1.3 Refrigerant piping length and height difference ...................................................................................................
7.2 Connecting the refrigerant piping..........................................................................................................................................
7.2.1 About connecting the refrigerant piping...............................................................................................................
7.2.2 Precautions when connecting the refrigerant piping............................................................................................
7.2.3 Guidelines when connecting the refrigerant piping..............................................................................................
7.2.4 Pipe bending guidelines .........................................................................................................................................
7.2.5 To flare the pipe end..............................................................................................................................................
7.2.6 Using the stop valve and service port....................................................................................................................
7.2.7 To connect the refrigerant piping to the outdoor unit .........................................................................................
7.3 Checking the refrigerant piping..............................................................................................................................................
7.3.1 About checking the refrigerant piping...................................................................................................................
7.3.2 Precautions when checking the refrigerant piping ...............................................................................................
7.3.3 To check for leaks...................................................................................................................................................
7.3.4 To perform vacuum drying ....................................................................................................................................
INFORMATION
Also read the precautions and requirements in the
4
precautions" [
NOTICE
The piping and other pressure-containing parts shall be suitable for refrigerant. Use
phosphoric acid deoxidised seamless copper for refrigerant.
▪ Piping material: Phosphoric acid deoxidised seamless copper.
▪ Flare connections: Only use annealed material.
▪ Piping diameter:
Liquid piping
Gas piping
▪ Piping temper grade and thickness:
Outer diameter (Ø)
6.4 mm (1/4") Annealed (O)
9.5 mm (3/8")
12.7 mm (1/2")
15.9 mm (5/8")
(a)
Depending on the applicable legislation and the maximum working pressure of the unit
(see "PS High" on the unit name plate), larger piping thickness might be required.
5].
Ø6.4 mm (1/4")
Ø12.7 mm (1/2")
Temper grade
≥0.8 mm
≥1 mm
7 Piping installation
|
"2 General safety
(a)
Thickness (t)
Installer reference guide
35
35
36
36
36
36
37
38
38
39
39
41
41
41
42
42
43
Ø
t
35