Table of Contents
Advertisement
Tilt Adjustment
CAUTION:
Execute this adjustment after releasing the angle restriction (opening angle at 90 deg).
1) Loosen the fixing nut on the back of the left hinge.
2) Rotate the hexagon socket bolt and move the fixing material to the marking line.
To move it forward: rotate it clockwise
To move it backward: rotate it counter clockwise
Fixing material Marking line
3) Tighten the fixing nut after adjustment.
8
Adjustment > Overview > Height Adjustment
Hexagon socket bolt Fixing nut
8
Adjustment > Overview > Height Adjustment
Height Adjustment
1. Check the height.
1) Close the DADF.
2) Check that the 2 height adjustment rolls on the front/rear left come contact with the stream
reading glass.
MEMO:
Turning ON the LED helps the check operation.
(Lv.1) COPIER > FUNCTION > MISC-R > SCANLAMP
Height adjustment roll
Height adjustment roll
3) If not, execute the height adjustment.
If you cannot check it visually, check it by the following method.
8-5
Stream reading glass
8-5
Advertisement
Table of Contents
