Do you have a question about the A&E 895 Series and is the answer not in the manual?
Questions and answers
leonard g blood
April 14, 2025
my awning will not open with switch checked switch has power going threw it .How can i open the awning so i can check motor and power comint to motor.i can not get it to open manually
1 comments:
Mr. Anderson
April 15, 2025
To manually open a Dometic A&E 895 Series awning and check the motor and power connection:
1. Remove the Power Patio bolt screw from the top casting. 2. Walk the awning to the closed position. 3. Connect the red wire to the positive terminal (+) and the black wire to the negative terminal (–) of a 12 VDC battery. 4. This will retract the awning if the motor and power connection are working. 5. To extend the awning, reverse the polarity: red wire to (–), black wire to (+). 6. Disconnect the battery source immediately after the awning is fully retracted or extended to avoid motor damage.
Do not use the awning until it has been serviced by a Dometic Service Center or qualified technician. Always reinstall the screw in the top casting to secure the awning during travel.
Page 2
Power Patio Awning User’s Guide SAFETY INSTRUCTIONS OPERATING INSTRUCTIONS This manual has safety information and instruc- To Open Awning: tions to help users eliminate or reduce the risk 1. Remote Rocker Switch a. Press and hold the “Extend” of accidents and injuries. button and the awning will au- tomatically open.
Page 3
This procedure will require two people. tom arm. When this procedure has been performed, the awning must be serviced by a Dometic Service Center or a qualified service technician before using again. Pinch Hazzard. When adjusting awning There are two methods of rolling up the pitch, bottom arm will telescope.
Page 4
Walk the awning to the closed Awning. If malfunctions occur that cannot be corrected by position. reviewing this Guide, contact a Dometic Service Center or 3. Align hole where screw was removed and replace a qualified service technician for assistance. Do not use screw into top casting to secure awning.
Need help?
Do you have a question about the A&E 895 Series and is the answer not in the manual?
Questions and answers
my awning will not open with switch checked switch has power going threw it .How can i open the awning so i can check motor and power comint to motor.i can not get it to open manually
To manually open a Dometic A&E 895 Series awning and check the motor and power connection:
1. Remove the Power Patio bolt screw from the top casting.
2. Walk the awning to the closed position.
3. Connect the red wire to the positive terminal (+) and the black wire to the negative terminal (–) of a 12 VDC battery.
4. This will retract the awning if the motor and power connection are working.
5. To extend the awning, reverse the polarity: red wire to (–), black wire to (+).
6. Disconnect the battery source immediately after the awning is fully retracted or extended to avoid motor damage.
Do not use the awning until it has been serviced by a Dometic Service Center or qualified technician. Always reinstall the screw in the top casting to secure the awning during travel.
This answer is automatically generated