Maytag Amana PMH Series Service And Troubleshooting page 50

SERVICING
LINE 1
HEATER 2
Evaporator
1. Remove front cover.
2. Remove the two mounting screws, one on each side
of the control board cover. Tilting the control panel out,
disconnect ribbon connector from control board. DO
NOT PULL ON RIBBON. GRASP THE BLACK RIBBON
CONNECTOR AND PULL GENTLY.
3. Remove the two screws securing the top screen to the
evaporator assembly. (Be sure to slide the top of the
screen between the top flange and chassis when reas-
sembling.)
4. Remove screws on mid partition panel and shift out of
the way.
5. Remove the two screws securing the heater assembly
to the evaporator.
6. Pull heater assembly up and out of the chassis.
7. Disconnect all wiring to the heater assembly and re-
move the assembly.
8. Remove the floodback protector or thermistor from the
evaporator discharge tube.
9. Remove screws holding evaporator to basepan and
partition panel.
10.After recapturing the refrigerant charge (see Refrig-
eration Service section), debraze the tubes into the
evaporator. Be sure to protect all chassis components,
especially foam parts, from excessive heat.
11.Lift the evaporator up over the basepan edge and re-
move.
HEATER 2
LINE 2 COMPRESSOR
50