Maytag Amana PMH Series Service And Troubleshooting page 20

SYSTEM OPERATION
CONSTRUCTION STYLE 1
Place magnet in Position A
in instances when the door
and frame align.
POSITION A
CONSTRUCTION STYLE 2
Place magnet in Position B
in instances when the door
POSITION B
CONSTRUCTION STYLE 3
extends into the room
beyond the door frame.
Place magnet in Position C
in instances when the door
extends into the room
beyond the door frame.
CONSTRUCTION STYLE 4
Place magnet in Position A
in instances when the door
frame extends into the room
beyond the door.
POSITION A
Above shows magnet 15/16" from the sensor mouting plate
in different slot positions.
NOTE: Two (2) 1/4" spacers are provided in this kit for
instances where the door is recessed behind the door trim.
See Construction style 4.
There is a line on the bottom of the DD01E and DD01F to
assist in aligning the magnet in the proper bucket location.
Above graphics are for example only. Always measure and
place the magnet in the proper slot to obtain the 15/16"
needed between the magnet and the sensor mounting
plate on the door frame.
THE ALIGNMENT GUIDE
IS AT 15/16" FROM
BACK PLATE.
ALIGNMENT
GUIDES
ON BOTTOM
OF DD01E
CENTER OF MAGNET
(IN HOLDER)
SENSOR
MUST BE 15/16" FROM THE
MOUNTING
PLATE
SENSOR MOUNTING PLATE
MPORTANT NOTE: When properly installed, the center
line mark on the bottom of the DD01E will line up with
the center of the line of the magnet holder containing the
magnet. Choose magnet position A, B, or C to align the
magnet 15/16" from the back of the DD01E or DD01F.
Door Sensor Operation Verification
NOTE: Do not attempt to bind a DD01E unless proper
operation has been validated.
To verify that door sensor is installed properly:
Spacers
(Two (2) 1/4" spacers
are included in kit)
DD01E
AIR CONDITIONING SENSOR
20