Switching On The Appliance/ Selecting A Programme; Change The Programme Default Settings - Siemens WM16Y849II Instruction Manual And Installation Instructions

Switching on the appliance/
selecting a programme
Press the # button. The appliance is
switched on.
The Siemens logo appears on the
display and all indicator lamps light up.
The Cottons programme set at the
factory is then always displayed.
You can:
use this programme or
■
select another programme on the
■
control panel or
select a programme under
■
Additional programs . ~ Page 12
If you have activated the
Note:
childproof lock, you must deactivate it
before you can set a programme.
The indicator lamp on the programme
selector lights up and the main menu
with the programme default settings
for the selected programme appear on
the display panel:
Temperature,
■
Spin speed,
■
Programme duration,
■
i-Dos settings,
■
Any additional settings and
■
Information on water and energy
■
consumption. ~ Page 8
Operating the appliance
In appliances with a drum light:
The drum is lit after switching on the
appliance, after opening and closing the
door and after starting the programme.
The light switches off automatically.
You can:
use the programme default settings
■
and load laundry ~ Page 28,
or change the programme default
■
settings and/or select additional
settings.
Change the programme
default settings
You can use or change the default
settings for each washing cycle.
To do this, repeatedly press the
corresponding button until the required
setting is displayed. ~ Page 22
Pressing and holding the buttons
Note:
automatically runs through the set
values.
The settings are activated without
needing to be confirmed.
After the appliance is switched off, the
i-Dos settings for i I ô and ô are
retained. All other settings are not saved
and must be selected again.
Programme default settings
~ Page 16
en
27