Faults And What To Do About Them - Siemens WM16Y849II Instruction Manual And Installation Instructions

Faults and what to do about them.

en
Display
Drum care
information:
Other displays
Error E:XXX
Faults and what to do about them.
Faults
Water is leaking from the
appliance.
The appliance is not filling
with water.
The dispenser is empty
and the fill level indicator
is not flashing.
The wrong detergent/
fabric softener has been
poured into the
dispenser(s).
Detergent/fabric softener
has congealed in the
dispensers.
The door cannot be
opened.
The programme will not
start.
The drum briefly jerks or
judders after the
programme has started.
The water is not draining.
42
Cause/remedy
This instruction reminds you to carry out the Drum clean 90 °C programme
or a 60 °C programme to clean and care for the drum and the outer tub.
Notes
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
■
only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergents designed for woollens or delicates.
Switch reminder information on/off. ~ Page 12
■
Switch off the appliance, wait for five seconds and then switch it on again. If the
display appears again, call the after-sales service.
Cause/remedy
Attach the drain hose correctly or replace it.
■
Tighten the threaded joint on the inlet hose.
■
Have you pressed the Ü button?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter.
■
Is the inlet hose kinked or trapped?
■
Is the drawer cover/connector dirty? Cleaning ~ Page 34
■
Has the detergent drawer been pushed in correctly? Insert correctly.
■
~ Page 37
Dispenser(s):
Empty and clean.
1.
2. Refill. ~ Page 32
Clean and refill the dispensers.
The safety function is activated. Cancel the programme? ~ Page 30
■
Is $ selected (Rinse Hold = no final spin)? ~ Page 30
■
Can the door only be opened by the emergency release? ~ Page 40
■
Have you pressed the Ü or Finished in button?
■
Is the door closed?
■
Is the w childproof lock activated? Deactivate. ~ Page 29
■
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash programme starts.
Is $ selected (Rinse Hold = no final spin)? ~ Page 30
■
Clean the drain pump. ~ Page 39
■
Clean the drain pipe and/or the drain hose.
■