User-Selectable Features - Clifford 500 Owner's Manual

Your ACE 500 vehicle security system allows you to set many of its features to
your own personal preferences. We have made the programming procedures very
simple: to make a change, you just flick the valet switch a few times. The system
comes from the factory with all of its features pre-programmed as noted in the table
below and on the next page. To change any of the settings, use the following
procedure. To restore the feature to its factory setting, just repeat the procedure:
1. Select the feature you wish to program from the table below and on the following
page. Note the number of flicks and chirps.
2. Turn your vehicle's ignition switch to its "ON" position.
3. Immediately flick the valet switch back and forth, counting the number of chirps
you hear. Stop when you reach the number of chirps associated with the feature
you wish to program.
4. If noted, perform the "Secondary action."
5. Wait 3 seconds. You will hear 1-5 chirps (as noted in the "Program completion
confirmation" column) and the LED will turn off. Turn the ignition off.
6. Repeat steps 1-5 for any other features you wish to program.
# of
Factory
Feature flicks &
setting
chirps
AutoArming 4
ON
AutoArm
5
OFF
& Lock
Chirp
6
ON
confirmation
QuietChirps 7
OFF
Headlight
8
ON
Reminder
AutoLock &
9
ON
AutoUnLock
Siren
10
30 sec.
duration
Tamper
11
OFF
Warning
FACT 12
ON
Add a new
remote to
13
—
channel 1
(arm/disarm)

User-selectable features

Secondary
action
—
—
—
—
—
—
—
—
—
Press remote control button 1
15
Program
completion Result
confirmation
1 chirp = OFF Change state from
2 chirps = ON ON to OFF or vice-versa
1 chirp = OFF Change state from
2 chirps = ON OFF to ON or vice-versa
1 chirp = OFF Change state from
2 chirps = ON ON to OFF or vice-versa
1 chirp = OFF Change state from
2 chirps = ON ON to OFF or vice-versa
1 chirp = OFF Change state from
2 chirps = ON ON to OFF or vice-versa
1 chirp = OFF Change state from
2 chirps = ON ON to OFF or vice-versa
1 chirp=60sec Change duration from 30 to
2 chirps=30sec 60 seconds or vice-versa
1 chirp = OFF Change state from
2 chirps = ON ON to OFF or vice-versa
1 chirp = OFF Change state from
2 chirps = ON ON to OFF or vice-versa
Button 1/channel 1 code
1 chirp of the new remote control
has been memorized
continued . . .