Zanussi ZRB33100WA User Manual page 15

Problem
The lamp does not work.
The compressor operates
continually.
Water flows inside the refrig-
erator.
The temperature in the appli-
ance is too low/too high.
Side panels of the appliance
are warm.
There is too much condensed
water on the rear wall of the
refrigerator.
Door does not open easily.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
Possible cause
The lamp is in stand-by mode.
The lamp is defective.
Temperature is set incorrect-
ly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The water outlet is clogged.
Food products prevent water
from flowing into the water
collector.
The temperature regulator is
not set correctly.
The food products tempera-
ture is too high.
Many food products were
stored at the same time.
This is a normal state caused
by operation of the heat ex-
changer.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrap-
ped.
You attempted to re-open the
door immediately after clos-
ing.
Solution
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation"/"Control
panel" chapter.
Wait a few hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Set a higher/lower temperature.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
Make sure that there is at least
30 mm of space between each
side of the appliance and the
surrounding furniture when the
ambient temperature exceeds
38°C.
Open the door only when neces-
sary.
Make sure the door is closed
completely.
Wrap food in suitable packaging
before storing it in the appliance.
Wait a few seconds between
closing and re-opening of the
door.
15