Table of Contents
Advertisement
Available languages
Available languages
Clean the appliance with a moist soft cloth. Only use neutral
•
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
Do not store explosive substances such as aerosol cans with a
•
flammable propellant in this appliance.
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
SAFETY INSTRUCTIONS
INSTALLATION
WARNING! Only a qualified person
must install this appliance.
•
Remove all the packaging and the transit bolts.
•
Do not install or use a damaged appliance.
•
Follow the installation instruction supplied with
the appliance.
•
Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.
•
Make sure the air can circulate around the
appliance.
•
At first installation or after reversing the door
wait at least 4 hours before connecting the
appliance to the power supply. This is to allow
the oil to flow back in the compressor.
•
Before carrying out any operations on the
appliance (e.g. reversing the door), remove the
plug from the power socket.
•
Do not install the appliance close to radiators or
cookers, ovens or hobs.
•
Do not install the appliance where there is direct
sunlight.
•
Do not install this appliance in areas that are too
humid or too cold, such as the construction
appendices, garages or wine cellars.
•
When you move the appliance, lift it by the front
edge to avoid scratching the floor.
ELECTRICAL CONNECTION
WARNING! Risk of fire and electric
shock.
•
The appliance must be earthed.
•
Make sure that the parameters on the rating
plate are compatible with the electrical ratings
of the mains power supply.
•
Always use a correctly installed shockproof
socket.
•
Do not use multi-plug adapters and extension
cables.
•
Make sure not to cause damage to the electrical
components (e.g. mains plug, mains cable,
compressor). Contact the Authorised Service
Centre or an electrician to change the electrical
components.
•
The mains cable must stay below the level of the
mains plug.
•
Connect the mains plug to the mains socket
only at the end of the installation. Make sure that
there is access to the mains plug after the
installation.
•
Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
USE
WARNING! Risk of injury, burns,
electric shock or fire.
•
Do not change the specification of this
appliance.
•
Do not put electrical appliances (e.g. ice cream
makers) in the appliance unless they are stated
applicable by the manufacturer.
•
Be careful not to cause damage to the
refrigerant circuit. It contains isobutane (R600a),
a natural gas with a high level of environmental
compatibility. This gas is flammable.
•
If damage occurs to the refrigerant circuit, make
sure that there are no flames and sources of
ignition in the room. Ventilate the room.
•
Do not let hot items to touch the plastic parts of
the appliance.
•
Do not put soft drinks in the freezer
compartment. This will create pressure on the
drink container.
11
Advertisement
Table of Contents
