Advertisement
Installing RemotEye III
Follow these steps to install the RemotEye III internal
card.
1)
Slide the RemotEye III internal printed circuit
board into the extension option slot of the UPS.
Secure the printed circuit board using the UPS-
supplied screws.(See Figure 1)
Configuration
RemotEye III must be configured for proper operation on its network.
Configuring the RemotEye III via Terminal
The RemotEye III can be configured by directly connecting to the device.
Hardware Setup
Direct configuration is accomplished through the provided PC cable. Follow these steps to setup
the hardware for direct RemotEye III configuration:
a) Connect the DB9 female end of the PC cable to the terminal or workstation COM port.
b) Connect the RJ45 end of the PC cable to the COM port of the RemotEye III/Internal.
Software Setup
The direct configuration is accomplished by using the RS232 communication protocol.
The direct communication can be performed from a workstation running Terminal
Emulator Software (TES)
Connecting to the RemotEye III via Terminal
A direct configuration session can easily be established once the hardware and software are
properly set up. Follow these steps to begin configuration
Terminal Emulator Example
To configure the RemotEye III from a Windows platform, use Hyperterminal. Hyperterminal is a
standard terminal emulator packaged with any Windows operating system. Launch the
Hyperterminal program by navigating to:
Start → Programs → Accessories → Communications → Hyperterminal → Hyperterminal,
and follow the prompts.
RemotEye III Quick Installation Guide – 63761-002
Figure 1: RemotEye III
Figure 1: RemotEye III Circuit Card
:
1
Advertisement
