Set Up - Before Use - Hercules HE041 Owner's Manual & Safety Instructions

SET UP - BEFORE USE

Read the ENTIRE IMPORTANT SAFETY
INFORMATION section at the beginning
of this manual including all text under
subheadings therein before set up or use of
this product.
Assembly
Dust Extraction Adaptor Attachment
For Fixed Base
1. Align the two raised ribs on the Dust Extraction
Adaptor with the slots on the Dust Port
located on the back of the Fixed Base.
2. Insert the Adaptor into the Dust Port.
3. Rotate the Adaptor clockwise until
it is secured on the Base.
Fixed
Base
Dust
Port
For Plunge Base
1. Position the Dust Extraction Adaptor on the
bottom of the Plunge Base as shown.
2. Secure the Adaptor in place with
the two screws included.
Screw
Dust
Extraction
Adaptor
Dust Extraction Setup
Connect a dust collection system (sold separately)
to the Dust Extraction Adaptor on the Fixed
or Plunge Base. A 1-1/4" diameter vacuum
hose can be connected to either Adaptor.
Page 6
Dust
Extraction
Adaptor
Plunge
Base
Screw
For technical questions, please call 1-888-866-5797.
Chip Shield Attachment
For Fixed Base
1. Place the Chip Shield in position and flex the sides of
the Shield while pushing in until it snaps into place.
2. To remove press inward on the tabs until the Chip
Shield releases from the Base, then remove.
Fixed
Base
For Plunge Base
1. Place the slot on the bottom of the Chip Shield
onto the screw on the Plunge Base.
2. Slide the Chip Shield to the right side to lock in place.
3. To remove slide Chip Shield to the left
side and remove it from the Base.
Chip
Shield
Chip Shield
Plunge
Base
Screw
Item 57368