Accton Technology Fast EtherHub-12se Installation Manual page 47

Fast EtherHub User's Guide
MDI-X Port (Medium Dependent Interface - Crossed)
This RJ-45 port, which crosses the receive and transmit signals internally, can be used
with straight-through cable to connect the hub to any device that has a standard network
interface (e.g., workstation, server or router). Pin-out assignments are shown in
Appendix B.
RJ-45 Connector
Most common terminator for twisted-pair wiring.
Star Topology
Physical connections for RJ-45 ports are limited to a star configuration (i.e., similar to a
hub and spoke arrangement). This topology also requires that only one path exists
between any two nodes, and that data transmitted by any node is concurrently available
to all other nodes within the same local network (i.e., immediate collision domain).
Station Port (MDI-X)
MDI-X ports which are used for connecting the hub to any workstation or server that has
a properly installed network adapter card. (For port 12, the selector switch must be set
to .) This port can also be connected to an MDI port on another compatible hub
MDI-X
or a switch.
STP (Shielded Twisted-Pair)
W
100 Category 5 twisted-pair wire covered with an external aluminum-foil or woven-
copper shield designed to reduce excessive noise pick up or radiation. The STP cable
refered to in this manual is also sometimes called screened twisted-pair (ScTP). Its
W
impedance is 100 and has the same pin assignment as UTP. This cable should not be
W
confused with the older 150 cable type designed by IBM.
UTP (Unshielded Twisted-Pair)
Cable composed of insulated wires twisted together to reduce electrical interference.
Glossary 3