Summary of Contents for Campania International Katsura FT-389
Page 1
FT-389 Katsura Fountain with Pedestal Assembly Instructions Fountain Information: • This fountain holds approximately 2 gallons of water. • This fountain uses a small fountain cover: FTNCOV-SM • No refill device or submersible lights are suggested for this fountain. Pump Information: WP450LV - 120 GPH Low Voltage Pump (16 ft.
Page 2
FT-389 Katsura Fountain with Pedestal Assembly Instructions Fountain Set-Up: Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is installed properly, please read our instructions and tips before you begin. Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Page 3
FT-389 Katsura Fountain with Pedestal Assembly Instructions Step 6 - Fill the basin enough to cover the pump completely with water to check for leaking. 6a - If leaking occurs… - Remove the stopper and repeat step 5 again. - Use some of the excess putty to seal the cord around the top of the stopper. See image “D”.
Page 4
Maintenance: Pump Care - The fountain relies heavily on the quality of the pump. A well-maintained pump can last several years. Step 1 - Fully submerge: Ensure the pump is fully submerged at all times to avoid damage. Step 2 - Ensure water level is sufficient: Check water levels regularly as water may evaporate over time, and periodically change water to avoid algae buildup.