Electrical Characteristics - Epson Mobilink TM-P80II Technical Reference Manual

Electrical Characteristics

Item
Dedicated Model: D241A
battery
(OT-BY80II)
USB charging
*1
Charging time 5 V/3 A
5 V/1.5 A
5 V/900 mA
5 V/500 mA
Continuous Wi-Fi model
*2
operating time
Bluetooth model
∗1: Charging time is the measured time from approximately 0% remaining charge to fully charged under the
following conditions.
∗The battery is new.
∗The printer is powered off.
∗Normal temperatures are defined as approximately 10 to 30°C {50 to 86°F} and low temperatures as
approximately 0 to 10°C {32 to 50°F}.
∗2: The test conditions are as follows.
∗ The battery is new.
∗ The battery is fully charged.
∗ Printed pattern is ANK 48 digits (Font A), 20 lines + paper feed by 6 lines.
∗ Printed once every five minutes.
∗ Performed under normal temperature of 25°C.
∗ Print density is 100%
∗ Access point used is CISCO AIR-LAP1142N-P-K9
∗ Wireless communication conditions: beacon interval is 200 ms, DTIM interval is 1, no broadcast
∗ The time it takes for the battery to go from fully charged to approximately 0% (E level).
The power saving mode can be set in "Wi-Fi" - "Energy Saving" of the TM-P80II Utility or TM Utility.
Rated voltage: 7.2 VDC
Capacity: Typ. 1950 mAh, Min. 1850 mAh
Approximate life span (number of charge/discharge cycles): 500 cycles
Note:
Epson cannot guarantee and is not responsible for the performance or quality of
3rd party USB charging devices. The following is provided as a starting point
reference to consider in selecting a 3rd party USB charging device.
Be sure to use Product that meets the following electrical specifications:
Minimum output 5.0 V/0.5 A
Maximum output 5.0 V/8.0 A
Be sure to use Product that meets appropriate and applicable safety
certifications, ratings and regulation, which apply in the region where the
product will be used.
For examples,
• FCC Part 15 compliant
• UL/CSA/TUV/ISED/CE/PSE/BIS/CCC etc.
When charging the printer, be sure to use the included USB Type-C cable.
At normal temperatures:
Approx. 2.5 hours
At normal temperatures:
Approx. 4.5 hours
At normal temperatures:
Approx. 15 hours
When the power save mode is enabled:
Approx. 25 hours
Approx. 47 hours
Note that the above continuous operating hours may vary depending on the operating environ-
ment and other factors.
Specifications
At low temperatures:
Approx. 5 hours
At low temperatures:
Approx. 8.5 hours
At low temperatures:
Approx. 29.5 hours
When the power save mode is
disabled:
Approx. 13 hours
Appendix
100