Subscribe to Our Youtube Channel
Related Manuals for Mastech MS8910
Summary of Contents for Mastech MS8910
-
Page 1: Table Of Contents
3-1. Product Illustration 3-2. Push Buttons 3-3. LCD display USER’S MANUAL 4. Specification 4-1. General Feature 4-2. Electrical Specification MODEL: MS8910 5. Testing Operation 5-1. Scanning Mode 5-2. Resistance Measurement 5-3. Capacitance Measurement 5-4. Diode Check 5-5. Continuity Check 6. Maintenance 6-1. -
Page 2: Introduction
1. Introduction 2. Safety Note The Tester is a handheld and battery operated very convenient small The following safety notes should be observed prior to using Tool that is specially used to measuring SMD （Surface Mounting This Tester and any associated accessory. Although the Tester do not used to Device), there are Chip type resistor, Chip type capacitor and diode, for measuring DC/AC Voltage or Current, but there are situations where example. -
Page 3: Explanation Of Controls And Indicators
3.2. Push Buttons 3. Explanation of Control and Indicators [1] “FUNC“ ： it is the function select key that acts trigger. 3.1 Product Illustration Use the Push Button as switch of Resistanc/Capacitance/Diode/Continuity. The Tester is have not Power Key. When install the 3V Lithium Battery, the Tester immediately power ON. -
Page 4: Lcd Display
3-3. LCD Display 4. Specification 4-1. General Feature ● 3000 count LCD display. ● Full automatic measurement: Auto scanning the Resistance/Capacitance/Diode. ● Function selection by one “FUNC” Push Button ● Data Hold function ● Continuity Checking function ● Over Load Indication ( ‘OL’) ●... -
Page 5: Electrical Specification
4-2. Electrical Specification 5. Testing Operation 5-1, Scanning Mode When install the 3V Lithium Battery, the Tester immediately power ON. Function Range Best Accuracy In this case, the ‘SCAN’ and ‘ - - - - ’ sign is displayed on the LCD. This Resolution ±(1%rdg+ 2dgt) is indicate the Tester is inter to the auto scanning mode and automatically... -
Page 6: Diode Check
6. Maintenance Caution To avoid damage to the Meter or to the equipment under test, 6-1. Replacing The Battery disconnect power and discharge all high-voltage capacitors When meter display , the battery must be replace to maintain before measurement capacitance. 5-4 Diode Check normal operation.
Need help?
Do you have a question about the MS8910 and is the answer not in the manual?
Questions and answers