Initial Use; Inspecting The Smoke Alarm - UNI 276324 Assembly, Operating And Safety Instructions

Drill two mounting holes according to the markings. The di-
ameter of the holes must be 5mm. Insert a plastic dowel
5
into each of the two mounting holes (see picture C).
Place the mounting plate on the plastic dowel .
4 5
Secure the mounting plate onto the plastic dowel
4 5
using the screws (see picture C).
6
Connect the battery and place it inside the battery
7
housing (see picture D).
8
Place the smoke alarm on the mounting plate . Turn the
4
smoke alarm in a clockwise direction until the smoke alarm
is locked in the right position (see picture E).

Initial use

Inspecting the smoke alarm

Test every smoke alarm to ensure correct installation and
operation.
Do not test the alarm with an open lame. This may cause
damage.
Test the alarm every week or after a prolonged absence.
During the test, stand at arms length from the smoke alarm
to avoid hearing damage.
Test all smoke alarms on a weekly basis as follows: press
and hold down the test button for approx 5 seconds. You
will hear 3 short signal tones, a pause lasting 1.5 seconds
48 GB