Working With The Copy Device; Disposal - Holzstar DB 900 Instruction Manual

6

Working with the Copy device

NOTE LUBRICATION!
Before starting up the copy device, all moving parts
must be lubricated.
DANGER!
Electric shock is life-threatening!
There is danger to life when in contact with live com-
ponents. Switched on electrical components can
cause uncontrolled movements and lead to serious
injuries.
- Before starting any adjustments to the machine, pull
out the power plug of the lathe.
WARNING!
Danger to life!
There is danger to life for the operator and for other
persons if they do not comply with the following rules.
- -Handling and working with the Copy device is per-
mitted only to persons who are familiar with the
handling and the mode of operation of the machine.
- The operator must not work if he is under the influ-
ence of alcohol, drugs or medication.
- The operator must not work if he is overworked or
suffers from fatigue and difficulties in concentrating.
- The Copy device may only be operated by one per-
son. Other persons must not enter the working area
during operation.
ATTENTION!
Danger of crushing!
In case of improver work on the Copy device, there is
danger to the upper limbs.
ATTENTION!
Before commissioning, check the electrical connec-
tion, lines and contacts of the lathe.
ATTENTION!
- Only work on workpieces that are securely clamped.
- Always keep sufficient distance to the rotating work-
piece.
Use ear protection!
Copy device | Version 3.02
Working with the Copy device
Wear dust protection!
Use protective glasses!
Use protective boots!
Wear protective clothes!
Step 1: Clamp the workpiece to be copied between the
tips (2, Fig. 1). Pay attention to a firm and secure
hold. In addition, a board with the copy mold can
be attached to the template holders (3).
Step 2: The fine adjustment of the turning diameter is
done by adjusting the turning dial (4). To do this,
loosen the clamping bush and position the tur-
ning tool to the desired length.
Step 3: To set the correct height of the turntable, the ad-
justment screws (6) must be screwed in or out.
The turntable should be just below the turning
center (about 1 mm). To determine the height,
move the turntable to just below the tailstock tip
or spindle tip. Then tighten the knobs (7) to fix
the set height.
Step 4: Adjust the preload force of the spring with the ad-
justment wheel (5).
Step 5: Insert the mains plug of the lathe and turn on the
lathe.
Step 6: During the turning, the dubbing pen must always
rest against the copy form. Guide the turning tool
simultaneously with the lever (8). The feed takes
place via the handwheel (9).
NOTE
The specialized trade offers a large number of books
and information material, which explains the art of
woodturning extensively and with all techniques and
tricks.
7

Disposal

In your own interests and in the interests of the environ-
ment, please ensure that all components of the machine
are disposed of in the proper and approved way.
5