Description Of The Device; Machine; Scope Of Supply; Assembly At The Lathe - Holzstar DB 900 Instruction Manual

Description of the Device

4 Description of the Device

4.1 Machine

The illustrations in these operating instructions
serve the general comprehension and may deviate
from the actual type.
Fig. 1: Copy device
2 Sample workpiece-holder
3 Template holder
4 Gouge
5 Dial for Spring-preload
6 Adjusting screws for Height setting
7 Clamping screws for Height setting
8 Guide arm for Pin
9 Handwheel for feed
10 Rear Clamp plate
11 Clamp plate

4.2 Scope of supply:

- Attachments for longitudinal and lateral turning
- Recordings for template
- Gouge
- Stylus
- Chip Shield
4
5

Assembly at the lathe

DANGER!
Electric shock is life-threatening!
There is a danger to life when you get in contact with
voltaged components. Electrical components which
are on can conduct uncontrolled movements and
cause severest injuries.
- Disconnect the mains plug before you start any
works on the machine.
DANGER!
The Copy device may only be used with the lathe
DB 900 or DB 1100.
Fig. 2: Assembly at the lathe
To install the Copy device on the lathe, proceed as
follows:
Step 1: Attach the Copy device with the clamping plates
(11, Fig. 1) to the machine bed (Fig. 2), align and
clamp in parallel.
Step 2: Due to the distance between the turntable and
the axis of rotation, the diameter to be turned can
be roughly adjusted.
Step 3: Adjust the total length of the workpiece over the
distance between the two outer holders (1, Fig.
2). To do this, loosen the rear clamping plate
(10) and the clamping screw on the guide rod to
move the holder.
Copy device | Version 3.02