Table of Contents
Advertisement
Error
Code
Error Contents and Cause
(SD0)
An instruction, which on execution
specifies other stations, has been used
2114
for specifying the host CPU. (An
instruction that does not allow the host
CPU to be specified).
An instruction, which on execution
specifies the host CPU, has been used
2115
for specifying other CPUs. (An
instruction that does not allow other
stations to be specified).
• An instruction that does not allow the
.under the control of another CPU to
be specified is being used for a
2116
similar task.
• Instruction was executed for the A or
QnA module under control of another
CPU.
A CPU module that cannot be specified
2117
in the instruction dedicated to the
multiple CPU system was specified.
When the online module change setting
is set to be "enabled" in the PLC
parameter in a multiple CPU system,
intelligent function module controlled by
2118
other CPU using the FROM instruction/
intelligent function module device
(U \G ) is specified.
*3
The function version is B or later.
*4
The function version is A.
*5
The module whose first 5 digits of serial No. is 04101 or later.
*6
The module whose first 5 digits of serial No. is 09012 or later.
*7
The Universal model QCPU except the Q02UCPU.
Corrective Action
Read the individual information of the
error using the GX Developer, check the
program corresponding that value
(program error location), and make
correction.
• When performing the online module
change in a multiple CPU system,
correct the program so that access
will not be made to the intelligent
function module controlled by the
other CPU.
• When accessing the intelligent
function module controlled by the
other CPU in a multiple CPU system,
set the online module change setting
to be "disabled" by parameter.
144
Corresponding
CPU
Q00J/Q00/
*3
Q01
*3
Qn(H)
QnPH
QnU
Q00J/Q00/
*3
Q01
*3
Qn(H)
QnPH
Q00J/Q00/
*3
Q01
*3
Qn(H)
QnPH
QnU
Q00J/Q00/
*3
Q01
*3
Qn(H)
QnPH
QnU
*3
Qn(H)
QnPH
QnU
Advertisement
Table of Contents
