PC Card Cage Removal
Figure 36. PC Card Cage Components
1 4-mm screw
2 PC card cage
3 System board
4 18-mm screws (4)
5 Audio bezel
This procedure assumes that you have removed the
the following steps:
1. Remove the 4-mm screw securing the audio bezel.
2. Remove the audio bezel.
3. Remove the four 18-mm screws securing the PC Card cage to the system board.
Use a support for the system board to prevent the board from flexing when the card cage screws are removed.
4. Gently pull the card cage off of connector UP9 on the system board. Do not rock the cage to remove it, because this may damage the
connectors.
Replace the PC Card cage if it is damaged.
Audio Card and Audio Thermal Shield Removal
Figure 37. Audio Card/Thermal Shield Components
system board
from the plastic case. To remove the PC Card cage (see Figure 36), perform