Spray Gun Setup; Positioning The Smartarm; Installing The Second Gun Kit (Optional) - Titan Powerliner 4500 Operation Manual

SPRAY GUN SETUP

4
SPRAY GUN SETUP
Follow the steps in this section in order to
i
properly install and/or position the spray gun(s).
4.1
POSITIONING THE SMARTARM (MODEL
2407312)
The SmartArm comes pre-assembled to the right
i
side of the frame (as looking from the rear of the
unit). If it needs to be moved to the other side,
follow these steps.
1. Loosen the gun riser clamp(s) (Fig. 4, item 1) and slide the
gun riser(s) off the gun support bar (2).
The cable ties that secure the gun trigger cables
i
to the bottom of the frame will need to be cut in
order to allow enough slack for the gun support
bar and gun(s) to be removed.
1
2. Loosen the main SmartArm knob (Fig. 5, item 1) and pull
the entire SmartArm assembly (2) from the cart frame.
12
2
4.2
1
3. Flip the SmartArm assembly (Fig. 6, item 1) around
and install on the other side of the frame. Tighten the
SmartArm knob (2) which is now facing the rear of the unit.
4. Reinstall the gun riser(s) onto the gun support bar.
5. Resecure the gun trigger cables to the bottom of the cart
using new cable ties.
Make sure the gun trigger cables and spray hoses
i
are positioned/routed in such a way as to not be
obstructing the wheels or interfering in any way
with the other components of the sprayer.
INSTALLING THE SECOND GUN KIT
(OPTIONAL)
Both models have an optional second spray gun
i
kit included. Follow these instructions to install
the second spray gun.
1. Assemble the second gun kit as shown. Tighten the knobs
on the clamp to secure the components.
PL4500
2
1