Kyocera FS-C5020N Basic Operation Manual page 68

Troubleshooting
Message
Close
rear cover
Close
top cover
Duplex disabled
Press GO
e-MPS not stored
Press GO
File not found
Press GO
Format error
Hard disk
Format error
Memory card
Hard disk err ##
Press GO
I/F occupied
ID error
Insert the same
memory card
Install MK
5-8
The rear cover of the printer is open. Close the printer rear cover.
The top cover of the printer is open. Close the printer top cover.
You attempted to print with a paper size and paper type that cannot be used for
duplex printing. Press [GO] to print onto one-side of the paper only.
The e-MPS job cannot be stored because RAM disk is disabled, RAM disk size is
insufficient, hard disk is not installed, or hard disk is full. Press [GO] to print error
report.
You have attempted to print a job that is not contained in the specified virtual
mailbox, or the specified virtual mailbox is not found.
If Auto Error Clear is set to On, printing will be automatically resumed after a preset
period of time. For details on Auto Error Clear, refer to Using the Operator Panel,
section of the Advanced Operation Guide.
The hard disk installed in the printer is not formatted, and therefore cannot be read
or written. To format the hard disk, follow the procedure in the Installation Guide of
the hard disk.
The memory card inserted in the printer is not formatted, and therefore cannot be
read or written. To format a memory card, follow the procedure in Using the
Operator Panel, section of the Advanced Operation Guide.
A hard disk error has occurred. Look at the error code given in place of ## and
refer to Storage Error Codes on page 5-12. To ignore the hard disk error, press
[GO].
This message is displayed when you attempt to use the printer's operator panel to
change the environmental settings on the interface from which data are presently
being received.
The user ID entered for a private job, or a stored job is not correct. Check the user
ID that you specified on the printer driver.
You have inserted the wrong memory card when the Insert again message
was displayed. Remove the wrong memory card from the printer's memory card
slot and insert the correct memory card. The printer again reads it from the
beginning of the data.
Replace Maintenance Kit which is displayed on the message display. Replacement
of the maintenance kit is necessary at every 200,000 images of printing and
requires professional servicing. Contact your service technician.
Corrective Action
BASIC OPERATION GUIDE