Lcd Display And Parameter Configuration; Information Display Interface; Device Parameter Display Interface; Parameter Configuration - Ebyte ME31-AAAX2240 User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.

4.8 LCD display and parameter configuration

The display interface includes information display page (current input value and DI input status display page,
network parameter display page) and parameter setting page (part of parameters).
[Note] After using the screen configuration, the device will open the static IP by default. After opening DHCP, do
not enter the screen configuration interface to avoid the device automatically turning off DHCP.

4.8.1 Information display interface

Including the current input value display page and the network parameter display page, short press the left and
right buttons to switch the interface, among which:
(1) The input display page displays the DI status of channels 1 to 2 from top to bottom and the current input
values of channels 1 to 2;
(2) The network parameter display page displays the local IP address, gateway address, local port, and local
Modbus address from top to bottom;

4.8.2 Device parameter display interface

The parameter setting interface from top to bottom is:
1. Local IP address;
2. Subnet mask;
3. Gateway;
4. Local port;
5. Modbus address;
6. Baud rate;
7. Data bits;
8. Stop bit;
9. Check digit;
10. Language;
11. Exit;
Among them, the data bits and stop bits cannot be set. After the DHCP mode is turned on, the IP address,
gateway, and subnet mask of the machine cannot be configured and are only allocated by the router;

4.8.3 Parameter configuration

Press and hold the confirmation button for 2 to 3 seconds on the information display page to enter the
parameter setting page;
Copyright ©2012–2022,Chengdu Ebyte Electronic Technology Co.,Ltd
0x0002 EVEN
ME31-AAAX2240_UserManul_EN
20