Maintenance And Troubleshooting; Environmental Protection - Wesco WS3113K Original Instructions Manual

MAINTENANCE & TROUBLESHOOTING
WARNING:Remove the plug from the socket
before carrying out any adjustment, servicing or
maintenance.
REPLACING THE CARBON BRUSHES (SEE FIG N, O)
The carbon brushes must be checked on a regular basis.
There are two brushes in the tool and they must be replaced
in pairs.
Remove the carbon brush holders with the spanner and
check the brushes. If the length of brush is less than 6mm,
replace both brushes. Have the machine run at no load for
15 minutes.
Note: Use only the correct type of carbon brushes.
Caution: Using the tool with worn brushes will permanently
damage the motor.
MAINTENANCE
Remove the plug from the socket before carrying out
any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.

ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
TROUBLESHOOTING
1. If your power tool does not start, check the plug on the
mains supply first.
2. If your power tool use in low efficiency, check the tool
speed and type of accessory.
3. If a fault can not be rectified, return the tool to an
authorized dealer for repair.
EN
PLUG REPLACEMENT (ONLY FOR
REWIRABLE PLUG OF UK & IRELAND)
If you need to replace the fitted plug then follow the
instructions below.
IMPORTANT
The wires in the mains lead are colored in accordance
with the following code:
Blue = Neutral
Brown = Live
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows.
The wire which is colored blue must be connected to
the terminal which is marked with N. The wire which is
colored brown must be connected to the terminal which
is marked with L.
Warning!
Never connect live or neutral wires to the earth terminal
of the plug. Only fit an approved 13ABS1363/A plug and
the correct rated fuse.
Note: If a moulded plug is fitted and has to be removed
take great care in disposing of the plug and severed
cable, it must be destroyed to prevent engaging into a
socket.
13 Amp fuse approved
to BS1362
Connect
Brown L(live)
Blue to N
(neutral)
Outer sleeve
Cable grip
clamped
13