Table of Contents
Advertisement
5.2. Selecting service mode
1. Turn on the power to the unit.
2. Make sure that no tape is inserted in the cassette deck. (Service
mode cannot be selected with a tape inserted in the cassette deck.)
3. Press the DOLBY NR button for about 2 seconds, and keep
pressing it, also press the STOP button for about 2 seconds. Refer
to
Fig. 5-1.
5.3. Deck 1 mechanism check
1. Press the Deck 1/deck 2 select button to change the flashing Deck
2 indicator to Deck 1. Refer to
Deck 1 indicator already flashing.)
2. Press the Deck 1 cassette holder open button to open the Deck 1
cassette holder. Refer to
3. Insert a CrO2 tape into the Deck 1 and close the cassette holder.
4. Press the Fast forward button. Refer to
forwards for about 2 seconds then stops.)
5. Press the PLAY button. Refer to
and check, the tape stops.)
6. Open the Deck 1 cassette holder and replace the tape with a
normal tape.
7. Close the Deck 1 cassette holder.
8. Press the Record pause button. Refer to
operation.)
9. Press the STOP button. Refer to
is displayed. Refer to Table 5-1. Each time the STOP button is
Fig. 5-1.
Fig. 5-2.
/ (No change required if
Fig. 5-2.
Fig. 5-2.
Fig. 5-2.
12
Fig. 5-2.
/ (Tape fast
/ (After TPS operation
Fig. 5-2.
/ (No record
A mechanism error code
Advertisement
Table of Contents
