Table of Contents
Advertisement
Connecting Digital Input Wires
5.4. Connecting Digital Input Wires
The Digital Input comes with photo-coupler isolation.
NOTE
The Digital High accepts 11 - 30 VDC.
The Digital Low accepts 0 - 10 VDC.
Connect the switch to Digital Input (DI):
1. Insert the wires into the 2-pin DI + and DI - contacts on the terminal block connector.
2. Tighten the wire-clamp screws.
5.5. Connecting to Ethernet
Connect the switch to a Ethernet network.
All eight available Ethernet ports are 802.3af/at PoE compliant. Each port can deliver up to
30 W, with a total PoE power budget of 120 W at 24 V input.
5.6. Connecting to a Fiber Network
Connect the switch to a fiber network via an SFP port.
The two available SFP ports are found above the eight Ethernet ports on the front of the
product.
SP2978 Version 1.1
®
Anybus
Managed Layer 2 PoE Switch
Page 11 of 16
Advertisement
Table of Contents
