Table of Contents
Advertisement
®
Anybus
Managed Layer 2 PoE Switch
5.3. Connecting Digital Output Wires
The relay output of the 2-pin terminal block connector are used to detect user-configured
events.
When a user-configured event is triggered, the two wires attached to the fault contacts,
form a close circuit. The fault circuit remains opened until a user-configured event occur.
NOTE
The relay contact supports 0.5 A current, DC 24 V. Do not exceed these
voltage and current limits.
Connect the switch to Digital Output (DO):
1. Insert the wires into the 2-pin DO contact on the terminal block connector.
2. Tighten the wire-clamp screws.
Page 10 of 16
Connecting Digital Output Wires
SP2978 Version 1.1
Advertisement
Table of Contents
Related Manuals for HMS Networks Anybus
Related Products for HMS Networks Anybus
- HMS Networks Anybus Wireless Bolt CAN
- HMS Networks Anybus Communicator
- HMS Networks Anybux Wireless Bolt Serial
- HMS Networks Anybus Wireless Bolt LTE
- HMS Networks Anybus-E300-DPV1
- HMS Networks Anybus Wireless Bridge II CAN
- HMS Networks Anybus Wireless Bolt II
- HMS Networks Anybus Communicator PROFINET to EtherCAT MDevice