Agilent Technologies Switch/Measure User Manual page 64

2
Features and Functions
• For scanning, the specified sample count sets the number of readings
• You can specify a sample count in conjunction with a trigger count and
• You can store at least 500,000 readings in memory and all readings are
• The
• The instrument sets the sample count to 1 after a Factory Reset
Front Panel Operation: Scan (Configure) > SAMPLE COUNT
Remote Interface Operation:
52
per channel (same for all channels in the scan list). If no channels have
been assigned to the scan list, the sample count sets the number of
readings per trigger for the internal DMM.
a sweep count. The three parameters operate independent of one
another, and the total number of readings returned will be the product
of the three parameters.
automatically time stamped. If memory overflows, the new readings will
overwrite the first (oldest) readings stored; the most recent readings are
always preserved.
and
CONFigure
count to 1.
( command). An Instrument Preset (
*RST
Card Reset (
SYSTem:CPON
commands automatically set the sample
MEASure?
command) does not change the setting.
SAMPle:COUNt
command) or
SYSTem:PRESet
34980A User's Guide