Installation; How To Use - Black & Decker BXAC9000E Instructions Manual

ENGLISH (Original instructions)

INSTALLATION

♦ Be sure to remove any packing material from the inside
of the appliance.
♦ Respect the legal provisions regarding safety distances
with other elements such as pipes, electric conductors,
etc.
♦ Make sure the appliance is level with the floor
♦ Do not cover or obstruct any openings in the appliance.
♦ The plug must be easily accessible in order to discon-
nect it in case of emergency.
MOUNTING THE EXHAUST PIPE:
♦ Stretch the tube, and screw its end to the air outlet
connector.
♦ The length of the air outlet pipe conforms to the technical
characteristics of the appliance. Do not use air outlet
tubes of different sizes or materials, as they may cause
faults.

HOW TO USE

USE:
♦ Unwind the cable completely before plugging in.
♦ Plug the appliance into the mains.
♦ Orient the appliance to direct the air flow to the desired
direction.
♦ Switch the appliance on by pressing the On / Off button
(a), (I)
♦ Select the desired mode
♦ Select desired speed
FAN SPEED:
♦ Under the cooling and the fan mode, the speed goes as
follow: Lower fan – Mid fan – High fan.
♦ Under the dehumidifying mode, the fan is working in low
speed.
TIMER FUNCTION:
♦ The appliance´s operating time can be controlled from
1~24h.
♦ Press that button. If you press the button once, the
appliance will be working for 1 hour, if you press twice, 2
hours, etc., up to 24 hours.
♦ Auto-shut off timer is only available when the unit is on.
♦ Under the cooling mode, the setting temperature ranges
from 16º~31ºC.
6
COLD MODE:
♦ Press mode to select cold mode, the cold mode indicator
will light up.
♦ Press + or - to set the temperature in a range of 16 ~
31 °C.
♦ Pressing + or - once, the temperature will increase or
decrease gradually.
FAN MODE:
♦ Press mode to select the fan mode and the fan indicator
will light up.
♦ Press speed to select high speed or low speed.
♦ Temperature and sleeping function cannot be setup.
DEHUMIDIFIER MODE:
♦ Press "MODE" to select dehumidifying mode, dehumidi-
fying mode indicator turns on.
♦ Under dehumidifying mode, sleeping function cannot be
setup, and fan speed is low.
SLEEPING MODE:
♦ Press key "SLEEP" enters into sleeping mode, default
value of fan speed is low.
♦ When sleeping mode turns on, under cooling mode, the
first one hour later, setting temperature will go up 1ºC,
the second one hour later, setting temperature will go up
another 1ºC, and then keep the same.
♦ Sleeping mode is invalid under dehumidifying and fan
mode. Under water full, machine standby and mode
conversion, sleeping mode will be cancelled.
Compressor protection:
♦ Three minutes after pressing on / restarting, the com-
pressor will start to operate.
Water drainage:
♦ When the inside of the water tank is full, the indicator will
light up on the display.
♦ The device enters the standby mode.
♦ Remove the plug to remove the water, turn the machine
off and on again, the machine will operate normally.
♦ This model has a self-evaporating function, in the cold
mode, please do not make continuous drains to get a
greater effect of cold.
Once the appliance has been used:
♦ Stop the appliance by pressing button (A) on / off
♦ Unplug the appliance from the mains.