Seakeeper 7000 Service Bulletin page 7

Procedure: ANNUAL INSPECTION INSTRUCTIONS
SERVICE
BULLETIN
3.2 Model 8000 :
3.2.1 Cooling System -

Remove coolant fill cap and confirm coolant level is approximately as shown in the below photo.

The Model 8000 glycol coolant pump typically runs only during RUN mode. For maintenance, the
glycol pump can be turned ON from the display. Press "MENU" repeatedly until the SERVICE page
is displayed. Press "DOWN" repeatedly until the "GLY PUMP" is selected and press "MENU". At
the GLYCOL PUMP page press UP and DOWN to turn the pump ON and OFF. Note that there are
minimum on and off times for the pump, so the pump may not immediately respond to a
command.
Check flow by removing coolant fill cap and looking in the top of the heat exchanger surge tank.
Correct Coolant Level
Model 8000 Coolant Level
Document #: Rev:
90133 1
Page:
7 of 16