STEINEL professional HPD2 KNX Quick Start Manual page 15

4.2 Display
4.2
– Enable night mode:
Enables infra red lighting during low light conditions.
– Disable night mode:
Infra red light disabled. No detection performed below 0.2 lux.
– Enable hi-res detection:
Detection is made in several sequential runs and can give better reliability. Detection time is four times longer however.
– After detection of the first person "safety detection" is enabled.
– Disable hi-res detection:
Detection on single frame is made in single run. This is normal behavior.
4.3 Reset
4.3
There are three ways to reset:
– Restart (sensor restart loss of settings).
– Reset to factory settings (all settings are lost, the sensor restarts).
– Press and hold reset button for 15 seconds for a software reset and reset to factory settings.
Bild 4.3 EN
– 15 –