BenQ V37X Product Service Manual page 56

5.3.2 Controls & Connectors
(1) AC power cord input: abbreviated labels
(2) User's Controls: standard print
5.4 Assembly Specification
ITEMS
Gap LCD Panel/bezel
Gap front/rear cover
Gap between other plastic parts
Step in the same plastic
Step between different plastics
LCD module centering
Cosmetic inspection shall be performed under specific time, distance, and lighting requirements as detailed
below. This is to be the first test performed on any new product, and is to be performed under normal
lighting of 500 lux as measured perpendicular to the work surface, and 250 lux as measured perpendicular to
the center of the display screen, per ISO 9241-3, unless otherwise specified. No magnification is to be used
except in the case of measuring LCD polarizer or screen defects. During a visual inspection, a judgment
must be made as to whether or not the end user would consider the flaw(s) objectionable. During this
inspection, only visual qualities are to be considered. The unit shall exhibit no objectionable defects under the
following inspection time and viewing distance criteria:
- Front panels: Inspect for 10 seconds at viewing distance of 500 mm.
- All other sides: Inspect for 5 seconds each at a viewing distance of 500 mm.
The following items are unacceptable if found during the time given for the inspection:
1. Missing parts.
2. Deformed case parts, control knobs, feet, or other parts.
3. Broken case or other parts.
4. Scratches greater than 0.5mm wide, or greater than 10 mm long, or greater than 0.2 mm deep.
5. Any scratches on the painted surface of any panel which allows the substrate material to show through
6. Any dirt or finger print
5.5 P
ACKAGING
5.5.1 Carton Dimension (W * H * D): 1130 * 875 *396
5.5.2 Shipping Weight : 31 Kg
5.5.3 Shipping Container: 40" 120 SETS; 20" 56 SETS
Specification
Please refer to C321
0.5<gap<1.5mm
<1.0mm
<0.8mm
<1.0mm
Viewable area cannot be hidden by the front
bezel
56